AnsweredAssumed Answered

Updating driven dims in design tables

Question asked by Don Eva on Jan 10, 2011
Latest reply on Jan 11, 2011 by Don Eva

Hi all,

 

I think this came up in a discussion a while ago, but I don't remember whether there was a good answer.

 

I have a design table with a fairly large number of configurations.  I've added some driven dimensions to the table.

However, when I open the design table these dimensions are all filled with the same (default) dimension.

 

I know if I close the table, double-click on each of the configurations in the tree, then reopen the table, the dimensions will update.  That's a pain in the neck with a large table.  Any solutions or macros available?

 

Thanks

 

Don

Outcomes