2 Replies Latest reply on Jan 13, 2011 1:11 PM by Bonnie Caruthers

    can a straight section be converted to aligned?

    Bonnie Caruthers

      I have decided to include some other features in a section so edited sketch by adding then editing lines to create an aligned section.  I did not get rid of my original section line, just trimmed it to a corner, then added another jog.  SW does not seem to understand what I did and just shortened my original section.

       

      Is this something that can be done?  I have my original section all dimensioned and would prefer not to have to do that all over again, though maybe I can drag all the dims and readjust them all.

       

      Would appreciate some help - getting a complex...

       

      using 2011 sp0

       

      thx,

      B