AnsweredAssumed Answered

Tube bend radius reverts to default during route

Question asked by Lars Larsen on Dec 30, 2010
Latest reply on Jan 17, 2011 by Anthony Read

I do a fair amout of tubing routing for hydraulic system design, and I keep running into the same problem with the tube bend radius being overridden in SW 2011.  I enter a radius value in the route properties menu  - i.e. 3" for a 1" tubing run.  When I start the route, the radius value defaults to 1", and I need to go back and change all of the radius values manually back to 3".  I've checked in system options, but I can't see anything that would cause this.  I never had the issue in SW 2009.  Any ideas?

Outcomes