Can I add structural members to 3D Sketch? I have a 3D curved sketch and I want to make it a rounded hollow steel tube.
Please help. Thanks
curved structural members are not allowed.
use the sweep feature instead.
Yes you can but not on spline. Here is a sample file from SW2011. The same can be done with SW2010 also.
If you have a spline, use Sweep option as Kenneth suggested.
i'm not using 2011 so i can't see your file.
i would have thought SW would have added this to What's New pdf since it is a major improvement.
Here is SW2010 file.
we stay one full release behind, so i'm just starting to use 2010 sp5.
yes i just did a trial in 2010.
very odd they don't mention this in the What's New!!!
I'm using SW2010 SP 4 but not sure if this was added with any SP of SW2010
Retrieving data ...