AnsweredAssumed Answered

How do I change the length of an added CPoint?

Question asked by Brandon Roeder on Dec 21, 2010
Latest reply on Dec 21, 2010 by Scott McFadden

Hello,

 

I am starting from a connector and then adding a point at the destination of my choice so I can navigate through a channel to that point.  I have found that Solidworks finds an error once I connect to the added point at the end.  If I make the last leg of this route straight and long enough, the error goes away.  How do I change/edit the length of my added connection point?

 

Thanks,

 

Brandon

Outcomes