AnsweredAssumed Answered

Dimension to angular hole

Question asked by Kris Persaud on Dec 20, 2010
Latest reply on Dec 21, 2010 by Kris Persaud

I'm trying to create the 2X .191 Basic Dimension shown in Attachment doc. This dimension (shown in Section A-A on the right hand of the drawing) is from the face to the center of the hole in the nozzle labled (Baloon1). I've added the center line to the hole but I cannot seem to dimension to the center point of the top of the hole to the surface as done in the attachment. The attachment drawing was done in SDRC but I'm re-creating the part and drawing in Solidworks