I have 2 strange problems and hope somebody can help me to solve them.
When I create a Sheetmatal part and save it as DXF, thc X Direction is changed.
here's a simple sheetmetal part:
and here's the DXF file:
As you can see DXF is mirrord (X).
Why this happens and how I can prevent it?
When the relief type of an Edge Flange is set to Tear,
the DXF file contains a small line.
Is it what it should be? In case of complicated parts, it's very hard to go through all the section
and delete the extra lines with a DXF editor.
A zip file containing both SheetMetal part and exported DXF file is attached.
thank you for any kind of help.