I have the following problem with my flow analysis.
The flow trajectories are going THROUGH my model. I selected all faces of the model. How can I solve this problem?
Mesh is too coarse and is not capturing the geometry very well. Check the tutorials on how to improve meshing with local initial meshes and other mesh settings. Flow documentation tip: Create shortcuts to PDFs
either your mesh is too coarse or your model is made of surfaces.
Flow sim only supports solids.
Yes, my model is made of surfaces. But I think there is no better way to model a car.
I am not saying that you should model your car with solids!! but that Flow Simulation needs solids.
From your surface..make it thick so that it is a solid and FloSim can handle it.
Retrieving data ...