7 Replies Latest reply on Dec 11, 2010 11:22 AM by Deepak Gupta

    Measuring a loft in a tubular part or converting/recreating the part in a SW file

      Hi there,

       

      I'm trying to rebuild an imported stp file. Basically it's a tube with 2 bends, I'm trying to rebuild the part but I'm having a bear of a time trying to figure out how to create a plane that will correctly allow me to make the next extrusion and then loft (or sweep) the two so that they join properly with the correct bend.

       

      Attached is the file that I'm working with.

       

      Thanks in advance,

       

      Nathaniel.