Does anyone have a better way of applying a GDT basic tolerance on a bolt circle callout of a multi-line annotation besides drawing a box with the sketch rectangle tool?
If this is a driven or added dimension you can select basic
from the property manager pulldown and added the GDT around it.
Is this what you are talking about.
Or you can add a box around an annotation note, but that becomes clumsy with adding the GDT.
I realize that but this only applies to the driven or driving dimension not the annotation after the dimension. See example provided!!
I think I would avoid the problem by dimensioning it differently as per this thread in Eng-Tips: http://www.eng-tips.com/viewthread.cfm?qid=191028
Agreeded see below:
Retrieving data ...