1-AMKYLF

Help - failure to satisfy velocity initial conditions

Discussion created by 1-AMKYLF on Nov 25, 2010
Latest reply on Jan 17, 2011 by Chad Schmidt

After running a number of different simulations in motion successfully, I have suddenly been getting this message:

 

Failure to satisfy velocity initial conditions.  A probable cause is an over-specification of initial velocities of bodies.  Please specify fewer initial velocities and try again

 

This occurs even when turning 1 shaft supported by 2 bearings via 1 motor @ 100 rpm and no other inputs. What can cause this?

Outcomes