I would like to add a 10mm fillet between 2 parts but I cannot specify the length, I can only add full length or intermittant, I am using solidworks 2009.
pls see attached zap grab to set property manager as you requirement.
Welcome to the forum,
In Assembly go --- Insert ---- Assembly Feature ----- Weld Bead.
Select your faces for the weld & size.
Then tick the box which says From / To.
This then gives you the option of where to start from & how long to make the weld.
See attached word doc for some screen shots.
Hope this helps.
Mark (SolidWorks 2011)
If you are in weldments go Insert --- weldments --- weld bead.
Note if you use Fillet Weld then the From / To option is not available.
Don't know the diffrence between using Weld Bead and Fillet Weld.
Retrieving data ...