4 Replies Latest reply on Nov 30, 2010 12:58 AM by Anna Wood

    Project Sketch

    William Dalpe

      I am perplexed! I have a roof elevation/slope that I need to "lay" 4 x 8 sheets of plywood on. I thought I could use project sketch but obviously that's a projection of the 4 x 8 sheet and does not wrap the 4x8 sheet on the slope. Can anyone give me some advice on this. I know I had learnt how to do this but cannot figure it out. I have attached a sample part model. I am trying to wrap the "4 x 8 plywood" sketch onto the sloped surface.

       

      I appreciate any insight!

       

      -Bill