AnsweredAssumed Answered

Routing limited to 1 connection

Question asked by Sean MacNeil on Nov 16, 2010
Latest reply on Nov 18, 2010 by Sean MacNeil

Vers. SW2011 Start route from a fitting run straight to a bracket with same fitting.  Add to rout on other side of bracket, that has same fitting and a line appears but it is not collinear as in SW2010 but, I connect it to a final fitting that is the same and no pipe shows up as a preview or after exiting creaeting a route.

 

Anyone experience this yet?

 

Thank you.

 

Machine is 64bit and running XP.

Outcomes