Hi there. I was watching a youtube tutorial and they had a hand drawn sketch which they where tracing over to create a new part. Is there a tutorial anywhere on this? I would really like to know how to do this.
Refer to this thread "PDF to sketch" (https://forum.solidworks.com/message/167873#167873), and I typically trace over a JPEG instead of a PDF by using:
Insert>Sketch Tools>Insert Sketch Picture (Imports the picture into an open sketch.)
To get the hand drawn sketch into a JPEG format, either scan the hard copy of the document or take a photo of it.
This is a similar post to what you are asking.
I hope you find it useful.
Retrieving data ...