Does anyone know on heming two sides how I can keep the corner ffrom looking like this. What I am looking for is a somewhat rounded end for assetics on the sheetmeatal part.
The only way I can think of is to weld it and polish it to suit. Think about how the material cuts in the flat and forms over. In order to close that outside gap you would have to cut the material on a bevel before bending and that's probably not going to happen.
The only way I can think of is to weld it and polish it to suit. Think about how the material cuts in the flat and forms over. In order to close that outside gap you would have to cut the material on a bevel before bending and that's probably not going to happen.
WT