I was able to fully define your sketch pattern. I have attached that model.
Also, I did it a better way. I used the circular feature pattern, instead of a sketch pattern. It is almost always better to use feature patterns. In this case, it inherently "fully defines" the pattern. In addition it makes it so you don't have to select all those edges for the fillet, you just pattern the fillet with the initial feature. Also, depending on the type of pattern, it can significantly reduce rebuild times.
Thanks for the quick response.
I guess no sleep from being up all night with a 10 month old takes its toll on a person. I am not sure what I was doing wrong. I attempted both sketch and feature patterns and could not get it to work.
Anyhow, thank you!