8 Replies Latest reply on Sep 13, 2010 12:09 PM by Kelvin Lamport

    Broken Breaks?

    Alan Stoldt

      BREAKER1-9.JPG

      B-sized Drawing Sheet. 2:1 Scale. View has been rotated 90 deg. to be horizontal. Breaks added.

       

      Breaks were offset (1 towards the top, 1 towards the bottom from thebeginning.)

       

      Bottom break was exactly the same as the top one until I tried to fix it.

       

      To fix it I changed from zig-zag cut to curve cut and the scale was off on one side, so I switched back and this is what I had. itried all other cuts and the scale from one side to the other is constant. I closed the drawing and re-opened and still the same. I did not restart SW or reboot the computer. yet.

       

      I'd be happy if there was an option for no cut line, but there isn't. As it stand, this looks sort of silly (keeping it mild for family viewing here...)

       

      Besides starting over again, any ideas or suggestions on how to fix this?

       

      I will try deleting and re-inserting the break in the bottom view after this is posted.

       

      Sometimes I just need to take a break from the actual SW and visit the virtual one.