In Solidworks 2D Editor you can type _config in the command line at the bottom of the screen you should get the options settings on screen. From here you can set the cursor size (Crosshair) to 100 percent. You can also change the snapping box size in the Snapping tab.
hope this helps,
Thanks a lot for putting in time and replying.
But this is not exactly what I want, i want to change the size of the little square box that is attached in front of the arrow.
That square box size helps us to select the objects, and if it is too small, then it is difficult to select objects fast.
I am sorry if my question is not clear.
I tried taking a snap by print screen for the arrow and selection box, but it does not appear in the picture.
Does anyone have a way to make that square attached to arrow pinter bigger.
Thanks for putting in your time to read.
I ran into the need for this today.
type pickbox into the command window. then reply with the size box you want. You can also get there through settings -> drawing settings -> coordinate input tab.
Raymond, You are a life saver.
My eyes were starting to give up after continuos selection with the smaller pickbox.
Thanks for the reply.