Ok, here is what we have. I have no experience other than the routing tutorial, so I have no idea how to do this.
We have a 45 pin connector. Of the 45 wires that exit the connector, some have varying lengths and end terminations.
For example, I may have 6 wires that go to a butt connector and all are 150" long.
If I insert a connector and route the wire, it would give me a length of the wire req'd. Now in order for me to place the other 5, I would have to insert another 5 butt connectors (I assume). The problem I forsee, is that these connectors will be side by side in the model, and thus it will give me different wire lengths. I want all wires to be the exact same length, with the same terminations. Same goes with some wires that are left bare.
Any help would be appreciated.