AnsweredAssumed Answered

change part to sheet metal part

Question asked by 1-NYIAQ0 on Aug 19, 2010
Latest reply on Aug 23, 2010 by 1-NYIAQ0

Hey all, If I have a part that i started as a normal boss extrude can I change that feature to a base flange?

I created a part as a machined piece and now they want to see it as a sheet metal piece, I thought I could just make a configuration of the same part but i can't add an edge flange to it?

Pretty new at this so not sure if it's even possible.




Mark S


SW2010 sp4.0