Solidworks (error message...see attached) is telling me that I have a path conflict with another toolbox install.
How can I confirm this? How might I resolve this issue?
I have searched for a pan_head_cross_ai and only came up with one part (highly used in our assemblies).
Using SW2009, sp3
thanks,
Jim
Deepak,
The path is unc friendly and set to network setup. It is a bit old school, as in Solidworks Data is not mentioned. I really don't want to post the entire path, but here it is disguised with asterisk:
\\*****fsr01.*****h.*******.com\NetApps\SWorksToolbox\Toolbox Parts\
(* in place of letters and integers)
We get the big green light for being set up correctly for network.
I have searched for Toolbox.ini and found nothing. I think that this is ok since the path is set in Tool box /Hole wizard folder in options???
thanks,
Jim
Jim,
Deepak is correct, but also check the install directory of toolbox and open the toolbox.ini file
and see where that is pathed to as well.
Scott,
Thanks.
I searched for Toolbox.ini and found nothing. I seem to remember that this went away with SW2007 or 2009.
Maybe adding it back would help?
<inserted image to show how old the mdb>
thanks again,
Jim
Seems like you have toolbox on both network and local hard disk. Go to Tools > Options > Hole Wizard/Toolbox and then set the path to the correct toolbox location.