Is there a way to add a configuration for a door open/door closed on a assembly containing a few doors on hinges? I tried everything and can't get it to work. Using SW2010
Is there a way to add a configuration for a door open/door closed on a assembly containing a few doors on hinges? I tried everything and can't get it to work. Using SW2010
Configure the hinge, one in open and one in closed configurations.
Then in your assembley make configurations in open and closed. Mate the doors to the hinge leafs. On the open configuration choose the hinges configuration of open, closed choose closed.
You need to create an Angle Mate between the hinge halves, and then adjust the angle in the config.
Ahhh. Got it....was so close.
Configure the hinge, one in open and one in closed configurations.
Then in your assembley make configurations in open and closed. Mate the doors to the hinge leafs. On the open configuration choose the hinges configuration of open, closed choose closed.