What specil font are you using here? If I try to work with the letters, the special letters turns to standard. Can you provide the font that furhterr investigation can be done?
Thank for your reply. I'm using "Vineta BT" font. I just double click the text in the sketch and I get the sketch properties and from there I can change the font style.
See attached file (corrected).
And this is what I did in troubleshooting your problem:
I used the "Check Sketch for Feature" tool and found out that the R was not dissolved and it had a self intersecting contour. After dissolving it, I used the "Check Sketch for Feature" tool again to pinpoint the area where the countour was self-intersecting. See below.
I too have experienced this as well.
What I have done is changed the width of the text ot the spacing of it in the text
editor inside of the sketch.
I called up your part quickly and I know when I have had to do text I create a surface
offset from the outside surface the text is going to be on to represent the depth of the
text. Then I create a plane offset in space and place the text on that and cut up to
surface. Then once that is done you can change the inside base face of the text letters
to what ever color you want.