4 Replies Latest reply on Jul 26, 2010 10:04 AM by Kelvin Lamport

    Dimensions going wonky!

    Greg Hynd

      Hello,

       

      I have a problem in that when i open a drawing some dimensions go wonky. i can put them straight by using align with edge, and then save it, but if i close and open the drawing again they have jumped back again.

       

      Have any others had this problem? I noticed in sp3 the dimension placement in this scenario tended to place the dims at an angle, while sp4 seems to have fixed this.

      Stair D1 glazing details 3049-029.1.JPG