6 Replies Latest reply on Sep 28, 2012 11:54 AM by Karan Lingerkar

Yellow Extrude Preview on Sketches

David Banks Jul 22, 2010 2:05 PM

When i am editing a sketch there is the Yellow preview that you see when extruding a profile. Even when i display as a wireframe is still get this preview. Why is this appearing and how do you turn it off.

Using SW 2010

Thanks,

Dave

Re: Yellow Extrude Preview on Sketches

Deepak Gupta Jul 22, 2010 2:16 PM (in response to David Banks)

Simply turn off the Instant3d
Like Show 0 Likes(0)

Actions
- Re: Yellow Extrude Preview on Sketches
  
  David Banks Jul 22, 2010 2:16 PM (in response to Deepak Gupta)
  
  "Simply turn off the Instant 3d"
  
  Thanks.
  
  Where might i find "Instant 3d"?
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: Yellow Extrude Preview on Sketches
    
    Deepak Gupta Jul 22, 2010 2:27 PM (in response to David Banks)
    
    David did you checked the link Instant3d
    
    Like Show 0 Likes(0)
    
    Actions
    - Re: Yellow Extrude Preview on Sketches
      
      David Banks Jul 22, 2010 2:31 PM (in response to Deepak Gupta)
      
      Got it. I didn't realize that was a link.
      
      Thank you so much.
      
      dave
      
      Like Show 0 Likes(0)
      
      Actions
    - Re: Yellow Extrude Preview on Sketches
      
      Karan Lingerkar Sep 28, 2012 11:54 AM (in response to Deepak Gupta)
      
      Deepak,
      
      What does it mean when an instant3d shows an arrow (to grab and pull) but is greyed out. Why is the arrow active only on some faces of the part and does not work when I want to increase the hole size by clicking the face and use instant 3d.
      
      I am guessing that the sketch (for hole in this case) should not be fullt defined? Is that right?
      
      Thanks
      
      Like Show 0 Likes(0)
      
      Actions
Re: Yellow Extrude Preview on Sketches

David Suelflow Jul 22, 2010 2:15 PM (in response to David Banks)

In many features there is an option for what type of preview you want (full, partial or none) but I don't see that for a basic extrude. I didn't see anything in the options either, sorry. I don't use instant 3D and I still get the yellow preview so I'm not sure that is it. Maybe someone else knows more…
Like Show 0 Likes(0)

Actions

Go to original post