Okay, I've been running x64 since April, and I have a major
issue with the routing add-in. It seems that if the routing add-in
is turned on & I go to open a drawing, it crashes, you open a
part from the assembly it crashes.
Two questions, anyone know of another work around other that
loading & then unloading the add-in?
Question two, why does SW release a DEFECTIVE product - then
come out with a beta version of another release when they don't
have the current release working correctly? Imagine buying a car
and every time you step on the gas it dies, you take it in for
service and the techs, say you have to wait until the r&d can
come up with a new carb, mean while they give you a bike as a work
around. (at least you have the lemon law as recouse there.)
Two questions, anyone know of another work around other that loading & then unloading the add-in?
Question two, why does SW release a DEFECTIVE product - then come out with a beta version of another release when they don't have the current release working correctly? Imagine buying a car and every time you step on the gas it dies, you take it in for service and the techs, say you have to wait until the r&d can come up with a new carb, mean while they give you a bike as a work around. (at least you have the lemon law as recouse there.)