AnsweredAssumed Answered

sheet metal: oblique extruded cut

Question asked by Brent Racine on Jul 15, 2010
Latest reply on Jul 15, 2010 by Wayne Tiffany

SW2010 SP3.0


I'm modeling up some old parts from hand drawings from the 70's.


One of the parts is bent from 1 inch plate, which makes me want to model it as sheet metal.


As far as I can tell tho, SW will only let me cut the sheet metal perpendicular to the face, but I need to cut 5 deg from normal.  Cutting at an angle just seems to make a larger normal cut.


Is there a way to make an oblique cut in a sheet metal part while keeping the ability to unfold?