2 Replies Latest reply on Jul 13, 2010 7:38 PM by Kris Dubuque

What the hect did I change in the options?

Carter West Jul 13, 2010 7:21 PM

For about three weeks now, I've been frustrated by something I obviously changed in the settings, options, or configurations.

In a sketch that has been fully defined, and I grab an entity (not node or vertex) and move it, it moves or copies it.

This series shows a defined box, and if I grab the line and move it I first get the warning, then it copies the line. If it's not fully defined, it moves the line. Neither of which is what I'm expecting to happen, nor did happen in 2009.

Please make it stop.

SW 2010 SP2.1

(I can't update to latest FIXES because they're holding them ransom)

Thank you all in advance,

Carter

Re: What the hect did I change in the options?

Kris Dubuque Jul 13, 2010 7:38 PM (in response to Carter West)

Check your settings under Tools, Sketch Settings. Make sure No Solve Move is not on, I think this is the one giving you fits. I checked my 2010 install and the "default" settings that are checked are: auto relations, auto solve and snapping.
Like Show 0 Likes(0)

Actions
- Re: What the hect did I change in the options?
  
  Carter West Jul 13, 2010 8:22 PM (in response to Kris Dubuque)
  
  Kris,
  
  You are DA man!! I was pulling what's left of my hair out looking in all the wrong places.
  
  Thank you so much.
  Man I love this forum
  'c'
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post