2 Replies Latest reply on Jul 13, 2010 2:47 PM by 1-RUI0A6

    Transient thermal stress analysis

      Hi All,

       

      I'm trying to perform a transient thermal stress analysis per the instructions in Simulation Help (help image attached).  Following the Help instructions, after I successfully run the transient thermal analysis to obtain the temperature distribution, I define a parameter for the temperature.  However when I am defining the properties of the study and go to the Flow/Thermal Effects tab of the Static dialog box and right-click the Time step box and select Link Values, there are no parameters shown on the list.  If I click "edit/define" on the parameters dialog box, the parameter I defined for temperature shows up but I can't select or use it.  Any ideas?

       

      Thanks,

      Chris