I would make a web catalog with assemplies/parts exported with ViewPoint,
I just using Instant Website to create a sample in my HD.
On local all run ok, but if I publish on my website, I can see nothing !!
Help me ..
Well going directly to the mtx or mts files gives a 404.
My guess is that a mime type may need to be added to owa.meccanicarossi.com:7200.
"Allowable file extensions" may have to be added for mtx and mts on the above server also.
You can't even access LOG files off that server. E.g:
There seem to be a lot of restrictions on that server.
You'll have to get the Sys Admin of owa.meccanicarossi.com to look into this.
Check path for the files for the web.
The path I think is correct,
If I browse in local is ok,
if the same page is browsed on web not run..
If you want can see the test on http://owa.meccanicarossi.com:7200/ViewPoint/3D/
the problem is source param (i think)
I have tried :
source = "MR00000233.mtx"
source = "/ViewPoint/3D/MR00000233.mtx"
source = "http://owa.meccanicarossi.com:7200/ViewPoint/3D/MR00000233.mtx"
but no-one run !!
I get this message " could not connect to owa.meccanicarossi.com:7200:
Try today to :
with this sample :
I have exported an assembly with Instant Website in 1STA00181 local folder,
then i have pulish in internal company site, and don't run...
the same folder i have published in my private website, hosted by a commercial hosting...
and RUN !!!!
What do you think is the problem ?
PS: in IIS the right settings are reading,writing,browsing and also enable scripting !!!
Retrieving data ...