No problems with other parts, just this one?
It unsupressed OK for me. I'm still on 2.1, as I'm not using 2010 for work yet.
Oops! Sorry, didn't read very carefully. It opens fine by itself and the flat pattern unsupressed OK.
I suppressed the flat pattern again and then opened a drawing and inserted the model for three views. I then unsupressed the flat pattern again and it didn't crash. I was able to insert a flat pattern view into the drawing as well, although I got an error about bend notes.
Sorry, using SW2008
My process is as follows, open drawing file, insert model (the attached one), check the box that says flat pattern under orientation….crash every time!
I'll attach the drawing file.
Crashes for me as well. I don't have a clue why. The part works with another drawing. Does the drawing work with other parts?
If you're on support, you could send the part and drawing to your VAR.
Seems to work fine here, but I'm on 2010 SP4.
I don't have any of the other parts on all the sheets, though. Could that be an issue? Try it with just that part available.
It was an issue with an early cut that wasn’t fully deleted, I couldn’t repair so I had to rebuild from scratch…fun
Retrieving data ...