AnsweredAssumed Answered

Use Smarter Assembly

Question asked by 1-R4SENZ on Jun 29, 2010
Latest reply on Jun 30, 2010 by Jerry Steiger

Dear all,


I'm working with a company now, that uses al this standard products, which all look like each other and use the same sketch and basics. The only thing that's changing are the dimensions.


For every production order we have to preform a pack&go to the folder of the order, with all the parts. Isn't it possible to have an assembly which remembers the dimensions and use the standard parts. So we only have to save the assembly.



(a little bit like the toolbox, i don't have to save the nuts and bolt seperately, but can use the toolbox-location parts)



Is this allready possible in SW2010 or is this something for SW2011?