AnsweredAssumed Answered

Different bend edges after converting to sheet metal

Question asked by Reno Simpson on Jun 22, 2010
Latest reply on Jun 24, 2010 by Reno Simpson

I start off by making a solid model, mirroring it so I have a identical left and right side.

then offset faces, thicken to .1345.  At this point they appear to be identical. I then use the insert bends tool and this is where then ends of the joining offset faces change from left to right?? I've tried using the different methods of relief but its still not the same from side to side??

no notch.bmp

notch.bmp

Outcomes