0 Replies Latest reply on Jun 16, 2010 2:53 AM by Anil Ghotekar

    Save as DWG-specific symbols are not coming properly

    Anil Ghotekar

      Dear All

           I have created a various dowel symbols in Gtol.sym.i placed the symbols in a table.Then i saved drawing file into DWG. But some symbols are not coming properly as shown in pictures. I checked all symbols are coming properly but where FARC command is used in Gtol.sym that symbols are not coming properly after save as DWG.

       

      SWSymbolBeforeSaveasDWG.JPG

       

      After saving in DWG it looks like

       

      SWSymbolAfterSaveasDWG.JPG

       

      Is there any way to create symbols that is also available in autocad.

       

       

      Regards

      Anil Ghotekar