6 Replies Latest reply on Jun 11, 2010 9:45 PM by 1-4EQZK9

    Call up Sketching Triad

    Rich Schneider

      Okay, I'm not a 3D sketch guru by a long shot.  But I'm reasonably sure that in SW 2009 I could call up the 3D sketching triad by being in a part file, right clicking in the graphics area and selecting it in the popup menu (while in a 3D sketch).  But I don't see it there anywhere in 2010 when I do this.  Any suggestions on what I might be missing?  I did the routing add-in, thinking it might be there.  But with the job being hot I need to get something going quick just to figure out some cable lengths.  Thanks in advance for any help.