2 Replies Latest reply on May 28, 2010 9:03 AM by Bill Hopcraft

    Error in ordinate dimension?

    Bill Hopcraft

      I've created a very simple model - just a plate about 4" x 6" with four holes.  The holes were all created with the Hole Wizard and the center of one of the holes is specified as 0.850" from the part  edge.  In the drawing for the part, however, this value shows as 0.851".  I've used ordinate dimensions to specify the hole locations.  I'm not using any formulae, or anything else where a rounding error could come into play, in the model.  What's up with this?