I'm having a problem trying to create a jog.
My condition is .078 mat'l., .080 jog height and .020 inside bend radius. (I didn't engineer this part, it's for a customer.)
Anyway, the customer's past experience with this mat'l. tells him to use a K-factor of .25.
It seems that SW wants to put a flat between the 2 radii where it should be just 2 tangent radii.
I can't seem to create the jog without the flat.
Dear Michael Closson
Do one think, first you make the model in the part mode & send it, It will be more helpful to go through it
Thanks & Regards
Radish.G