AnsweredAssumed Answered

Linear Pattern part not holding its position.

Question asked by David Suelflow on May 19, 2010

I have a part that is in a linear pattern and when I try to mate something to it, it gets pulled to the mating part rather than the other way around.

Notice how the purple walls are not lined up like the pink ones (see picture).

 

I've noticed this before and it usually will correct itself if I do a Ctrl-Q but not this time.

Any thoughts on how to get it back in line or what is happening?

 

I've did the system maintenance in SW RX and rebooted (3 finger salute) to no avail…

Attachments

Outcomes