AnsweredAssumed Answered

loss of SolidWorks file type icons

Question asked by Peter Gumprecht on May 12, 2010
Latest reply on May 12, 2010 by Josh Brady

I was wondering if anyone else has run into this when upgrading.

I'm upgrading (XP 32 machines) from SW 2008 sp5 to SW 2010 sp3. Did a complete un-install

of SW2008, cleaned out the registry and then installed the new SW 2010 sp3.

When in SW and I select file open I do not have the icons associated with part,

assembly or drawing. They are generic windows icons.

I have deleted the original file types and recreated and re-associated them with SW.

This fixed the windows explorer icons but not the icons within SW itself. Strange......

Thoughts and suggestions welcome.