Please go through the attachment you can understand my doubt
Please help me to solve this problem.
The angle on your bend is controlled by the sketch. Change the angle in the sketch and it changes the angle in the bend. The bend is created tangent to your existing geometry.
Could you elaborate more?
Sorry Radish, but what is the problem?
Are you trying to keep both angles the same? In which case LINK the angles or make the 2 bottom horz sketch lines collinear.
If it the Tolerance/Precision of the angle you need to change that is on the feature manager when the select the dimension.
Ah got your problem, didn't look at the drawing
Will have a look at it for you.
Dear Michael Duncan,
Ya you are correct. I got it.
Thank you for your instant reply
Thanks & Regards
Dear Geoffrey Leonard
Kindly go through my attachments you can understand exactly what is the problem
(Go through the note below the drawing also)
In the drawing select Options, Document Properties, Units, Angle and set the Angle Decimals to .1
See attached. Maybe this could be an alternative.
Retrieving data ...