5 Replies Latest reply on May 7, 2010 11:34 AM by 1-I7AP5K

    Sloppy Sketching or SW Error?

    Tom Strohscher

      This has been bothering me for some time now and I finally shouted around the office to find other have the same issue.

       

      I was having trouble extruding this simple sketch.  As I dug into the issue I find a .004" line extending out where I put no line. (Rectangle is 1.5"x2.25")

      Initially it just looks like I was sloppy when I create my sketch.  But this happens over and over.  I'm triing to pay closer attention to my sketchs but I can't figure out what I'm doing to create this extra line.

       

      In the last two days I have modeled 150 parts for an assembly I'm redesigning and I have seen this problem come up quite often.  When I asked others in the office they thought the same as I that they were just getting sloppy.

       

      What are we doing wrong to to continuously get this little extra line?

       

      Are others seeing it too?