AnsweredAssumed Answered

Overall Dimensions in Flat

Question asked by Tim Dunbar on May 6, 2010
Latest reply on May 10, 2010 by Deepak Gupta

Sorry I know this had to of been covered before, but I was unable to find the correct awnser in my searching.

 

In my part properties I drive the stock size with my dimensions.  When I lay my sheet metal flat I do not have overall dimensions to drive my stock size.  So is there a way to add/show overall dimensions.  If not what is the best way to get an overall size on a flat sheet metal piece.

 

Thanks

Outcomes