Hello evrybody,
How I linked part item number of BOM in main assembly drawing to another part detail drawing? (I using SW2010)
Ismail,
I've asked the same question. I do not kow about SW 2010, but in SW2009 SP5.1 it isn't possible to use the Item numbers generated by the SW Bill Of Materials on other drawing sheets.
I'd like to see this functionallity added.
Good luck.
Ismail,
I've asked the same question. I do not kow about SW 2010, but in SW2009 SP5.1 it isn't possible to use the Item numbers generated by the SW Bill Of Materials on other drawing sheets.
I'd like to see this functionallity added.
Good luck.