Hi to all!
In BOM I have two pipes with same diameter but different length, they are showing the same weight. Even if I change the length of these pipes still they have the same weight.
Any help, please!
The reason you have the same weight for all configurations is that your weight/mass property is in the 'Custom' tab and not in the 'configuration' tab; therefore the pipe weight shown in the BOM will always be the weight of the open configuration.
Hope this helps.
If you change the length, do the weight value changes or remain same? Can you put the pipes here to check (can be an issue with some settings)
Yes, the weights do not change even I change the lengths.
I just took the pipe from the library and made some changes of its parameter .
The weight in the BOM does not match if I check it by Mass Properties.
I am attaching the pipe I created.
Oops can't open up, higher version file.
Works for me Fine in 2010 sp2.1
make sure "assigned mass properties" in not checked
I have opened your part and found no problem
You are correct! I tried it and it works. Thank you for your big help.
Retrieving data ...