Hi Andy,
We just upgraded one seat of SW2010 service pack 2.0 to premium with the intent to use electrical and piping routing. We also use PDMworks to vault and revision control our product assemblies, parts, and drawings.
What, if any , is a workable procedure to use routing within the context of revision control and the PDMWorks vault. For example, we use the same electrical harness in more than one product.
Our VAR has not been able to answer this question for us, even after we attended the one day training.
Regards,
Jack Kellythorne
Hi Jack,
I am no expert on PDM but I do know that there are customers that use both.
There is a document on the knowledge base detailing how to setup Enterprise for routing. There isn't anything I am aware of for PDMW which will be slightly different.
I would suggest you push your reseller to get you the help you need. They can contact our Tech support for information.
Cheers
Andy