You can add a tab on the flat side of the part that would go past the bent part of up to it.
If you have the file in SW 2009 I can show you. Cannot open 2010
I guess this option wasn't available in 2009 but in the 2010 version on the sheetmetal toolbar there is the option "Corners"
You just select the faces of the corners you want to meeting eachother and it will do it automatically all for you.
Take a look at that file.
Added one "tab" and changed the parameters of your sheet metal creation.
The faces are .022 apart.
The closed corner feature does not do anything about the gaps at the bend rads
Dear Matthew Neesley,
Go through my attachment & tell me, am I correct or not.
Thanks & Regards
Retrieving data ...