Toolbox and SW2005 and 2006

Discussion created by Guest on Apr 25, 2006
At my company we have SW2005 and SW2006 running. When I installed 2006 I specified an alternate location for toolbox parts. We run both versions of SW just in case one of our vendors hasn't upgraded. My question is when we finally decide to get rid of 2005 is that going to kill all of my assemblies that was using SW2005 toolbox parts? What is the best way to handle toolbox parts when running multiple versions? If I use a common folder, then SW2005 cannot use toolbox parts.

Thanks,
Dan

Outcomes