2 Replies Latest reply on Mar 17, 2010 12:49 PM by Billy Oliver

    What is the easiest way to denote EMI shielding locations on a complex injection molded part

    Billy Oliver

      I have tried several techniques. Using 2D sketch in drawing views.....  but it looks like that has a selection limit and an updating issue.

       

      I tried offsetting surfaces .001" and triming them back etc in the part... but that shows up only in the drawing is shaded mode or full wireframe and is tedious.

       

      Now I am going to go back to the part and define a plane and do a wireframe sketch in a planer view and try that.

       

      Does anyone know the most efficient way to do this.  What about split part splitting surfaces.

       

       

      I tried to surface hats but that looks like you can only select one surface at the time.

       

      Thanks Billy