AnsweredAssumed Answered

Manually creating a Flat Pattern

Question asked by Pankaj Bir on Feb 20, 2010
Latest reply on Feb 23, 2010 by Anna Wood

Do you think it is possible to create developments manually using solidworks.


Whenever you get stuck trying to extract the development of a part that will not flatten have you ever wondered whether you

could do it manually.


This is the new challenge for all you guys there. How would you extract the geometric information required to create the flat



That is when the going gets tough. The tough get going !!!


Any thoughts on how the entire sheetmetal flattening code works !!!!!